231 Boltherm

Presentation

Composition
Thermal insulation composed of double aluminium protected and double air bubble.

Main Applications
Suitable use in: Roofs and floors

Main Benefits
The reflective aluminum capacity in conjunction with twice the air make the compound isolation even more effective and appropriate to the situations of big technical requirement.

Features
Thickness (mm)8
Presentation – (m2)40
Length x width (m)33 x 1.20
Weight (g/m2)430
Emission factor (%)5
Thermal Resistance1.56 m2 .° C/h Kcal
Reflectance (%)95
Thermal conductivity (W/mk)0.020
Maximum compression (kg/m2)1000
Toppings

The appropriate treatment of the covers is one of the most important steps to ensure the thermal efficiency of buildings. The process of boltherm insulation goes against heat transfer: – for radiation, which is an essential component of energy transferred through the covers (particularly in summer, when you can get up to 93%); – by conduction and convection, due to the air bubble in the material and the process of assembling, with dual air box (2 cm deep, at least).

About/Plate Slab

thermal insulation on board

Any insulation placed in low tile must always obey the installation instructions so as not to compromise the effectiveness of your application.

1. fixing of retractor upwards

2. Boltherm placement in longitudinal direction

3. coverage Treated

Pavement

Treatment of terraces after waterproofing

A simple solution: easy maintenance, waterproofing. The terraces, more than any other area, are very exposed to solar radiation. Boltherm proposes the treatment of these areas by combining a geotextile and a reflective insulation which is applied a lajetas floating floor. This solution is simple to use, allows easy access for maintenance operations, and gives an additional guarantee of waterproofing.

Inverted coverage with Floating Lajetas

1. Constitute placing of geotextile (+/-150 g/m2) on waterproofing layer.

2. Boltherm application (sealed joints with aluminum tape)

3. The placement of the brackets/support:
-Fixed, adjustable for height, sticking self-levelling compounds.
-The use of the base holders protection will prevent any damage occur in Boltherm isolation.

3. The placement of the brackets/support:
-Fixed, adjustable for height, sticking self-levelling compounds.
-The use of the base holders protection will prevent any damage occur in Boltherm isolation.

4. Placement of lajetas chosen on the brackets.